In case you are standing amongst those users who are experiencing the Netgear extender red light problem, then your search engine has redirected you to the right article. The reason being, here, we have talked about the best troubleshooting techniques through which you can resolve the Netgear extender red light issue in a hassle-free manner.
However, prior to reading the solutions mentioned below, it is recommended that you do WiFi extender setup properly. You can either use the WPS or manual method to set up your networking device from scratch. By any chance, this does not work for you; you should get down to the fixes without wasting any more of your precious time.
How to Resolve Netgear Extender Red Light Issue?
1. Restart If Netgear Extender Red Light Blinking
Start the troubleshooting process by restarting your Netgear wireless range extender. To give your device a new start, you ought to put the power button to use. Restarting the WiFi device will help you to eliminate every external factor that could have caused the issue in discussion. Once you have rebooted your device, let the LED light become green.
If you want better results with the reboot process, then instead of just restarting the WiFi range extender, you should power cycle the entire WiFi network.
2. Check the Cable Connection
The second reason that could have caused the Netgear extender red light problem is that the cable connecting the networking devices is damaged. To resolve it, use a damage-free cable to connect the devices. Would you rather get out of the web of cables? Well, in that scenario, you should make use of a wireless medium to pair the WiFi devices.
See to it that the distance between the extender and router is neither too much nor less as too much of it causes irregular signal transmission and too less can make the signals clash.
3. Repair the Damaged Socket
Is your Netgear range extender getting an adequate power supply from the wall socket? No? Well, you have just discovered the third reason why you are stuck with the red light issue. The electricity might be inadequate because the wall socket is short-circuited. To take care of the problem, you need to get the damaged wall socket repaired.
Do you not have the time to call an electrician? No problem. Plug your range extender into another socket. Just ensure that it is in the same room where the router is kept.
4. Upgrade the Firmware
Updating the Netgear extender firmware is yet another solution to convert the status of the LED light from red to green. You can use the Netgear Nighthawk application or the manual method to update the firmware of your networking device. In case, you are not sure how to use any of these methods, read the steps given in the product manual.
For your information, the manual also contains info on topics like how to change the device password, steps to hide the network name, and how to do Netgear WiFi extender reset.
5. Change the Device Location
Despite reading all the troubleshooting solutions mentioned above, in case you are still trying to make amends with the issue in debate, then you should change the location of your networking device and keep it away from washing machines, microwave ovens, baby monitors, cordless phones, treadmills, televisions, refrigerators, and other similar devices.
You ought to know that reflexive surfaces can also mess with the signals of your extender. Thus, avoid keeping the extender anywhere near glasses, mirrors, and fish tanks.
We are concluding this article with the last troubleshooting technique. In case the LED light on your networking device is still blinking red, then it is suggested that you do not think twice prior to resetting your range extender. To restore your Netgear extender, you need to walk through the procedure given in the user manual.
Once you have reset your networking device, check whether the problem at hand has been fixed. In case it has, then you should drop a few words of appreciation in the comment section for your fellow readers to read. Wondering who they are? Well, they are the others who are going through this post along with you.
Read more- Netgear Orbi Firmware Update Stuck Issue